Technical
AD 481: Composite beams with deep composite slabs
It has come to SCI’s attention that composite slabs with an overall depth/thickness in the range of 200 mm to 250 mm are becoming increasingly common, …
New and revised codes and standards from BSI Updates March 2022
BS EN PUBLICATIONS BS EN ISO 3382-3:2022Acoustics. Measurement of room acoustic parameters. Open-plan officessupersedes BS EN ISO 3382-3:2012 PUBLICLY …
Portal Frames with flexible joints
In the second of two technical articles considering the effect of allowing for joint flexibility in the analysis and design of portal frames, Richard Henderson …
Temporary fixing of metal decking
mme of work with the Building Research Establishment (BRE) in 2019 to carry out a series of dynamic wind tests on steel decking sheets, followed by a series of …
AD 480: Correction to P399 Appendix F Worked Example
It has been brought to our attention that in the worked example presented in SCI publication P399 Design of steel portal frame buildings to Eurocode 3, the …
New and revised codes and standards; from BSI Updates February 2022
BS EN PUBLICATIONS BS EN ISO 10675-1:2021Non-destructive testing of welds. Acceptance levels for radiographic testing. Steel, nickel, titanium and their …
Portal frames with flexible joints using Kleinlogel-type formulae
Single-span portal frames with flexible joints can be analysed using formulae similar to those produced by Kleinlogel. Concept designs or “hand” checks of …
AD 477: Transverse bending of composite slabs subjected to point loads
In order to retain the accurate formatting of the equations in this technical paper, this article is available as a pdf download only. Click here to download …
New and revised codes and standards, from BSI Updates January 2022
BS EN PUBLICATIONS BS EN ISO 15614-13:2021Specification and qualification of welding procedures for metallic materials. Welding procedure test. Upset …
New and revised codes and standards: from BSI Updates November and December 2021
BS EN PUBLICATIONS BS EN 508-1:2021Roofing and cladding products from metal sheet. Specification for self-supporting products of steel, aluminium or stainless …
