Tag Archives
AD 520: Amendment to Table 8 in the MPS-Bolts (issue 14)
The BCSA has reviewed the requirements for impact test for machined test pieces in Table 8 of the Model specification for the purchase of structural bolting …
AD 519: Equivalent horizontal forces and combinations of actions
Recent questions to SCI’s Advisory Desk have shown that some designers are unclear whether equivalent horizontal forces (EHFs) should be applied to a …
AD 515: Welding of structural nuts and bolts
SCI’s Advisory Desk has recently received queries from designers asking if it permissible to weld structural nuts and bolts – typically for situations …
AD 512: Eurocode requirements for wind bracing connections
AD 509 reminded designers that according to BS 5950, preloaded assemblies are not required when reversal is solely due to wind loading. The AD recommended that …
AD 509: Non-slip connections in wind bracing
SCI have received reports that frame designers are specifying non-slip connections for wind bracing – typically on the elevations or in the roof – noting …
AD 507: Galvanizing steel of grade S460M
SCI has recently been asked whether the heating of thermomechanical rolled steel of grade S460M when subject to hot-dip galvanizing will affect the properties …
AD 504: Web to flange welds in box sections subject to bending and torsion
SCI has recently been asked about sizing welds between webs and flanges of a fabricated box section subject to applied torsion and bending. This AD note gives …
AD 502: Design to BS 5950 and other standards
The Advisory Desk is regularly asked whether it is acceptable to carry out structural designs to standards other than the Eurocodes. This note draws attention …
A milestone in advisory desk notes
The issue of AD 500 marks a significant achievement in the provision of technical advice to the steel construction industry. Advice was issued from 1988 within …
New Steel Construction Technical Digest now available online
New Steel Construction’s (NSC) seventh Technical Digest, which brings together a year’s worth of technical guidance, is now available for download at: …